Re: [Xen-users] domU network problem phase II

["Alessandro R." <lord2y@xxxxxxxxx>]

2007/1/10, Luke S. Crawford <lsc@xxxxxxxxx>:
> Frst verify you have network access from Dom0.
In dom0 e1000 works fine.

> Assuming you do, post the output of
>
> brctl show
>
> run within the dom0 while the DomU is running.
nrt02 log # brctl show
bridge name     bridge id               STP enabled     interfaces
xenbr0          8000.feffffffffff       no              vif0.0
                                                       peth1
                                                       vif5.0


> also post the output of
>
> ifconfig eth0
>
> on the dom0, where eth0 is the name of the interface that your dom0 gets
> network access through.
e1000 is eth1 for me:

eth1      Link encap:Ethernet  HWaddr 00:15:17:0E:64:27
         inet addr:192.168.2.200  Bcast:192.168.2.255  Mask:255.255.255.0
         UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
         RX packets:19221 errors:0 dropped:0 overruns:0 frame:0
         TX packets:431869 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:0
         RX bytes:1706431 (1.6 Mb)  TX bytes:93381642 (89.0 Mb)


--
Alessandro R.
Hp. http://lord2y.lunimig.org

NOTICE
This message is for the named person's use only and it's confidential.
If you receive this message in error, please immediately delete it and
and notify the sender. Thank you.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users