| |
|
 |
|
 |
|
|
|
| |
|
|
xen-ppc-devel
Re: [XenPPC] Booting Dom0 with SLES10 on JS21
On Jul 11, 2006, at 2:08 PM, Jimi Xenidis wrote:
On Jul 11, 2006, at 1:44 PM, poff wrote:
Xenidis wrote:
Then try using <linux build>/arch/powerpc/boot/zImage.initrd as
your
Dom0
Much better... However still endup with:
INIT: Id "1" respawning too fast: disabled for 5 minutes
Those are entries in /etc/inittab, it usually means that getty
doesn't like the device it is associated with.
There still might be some udev issues.
It occurs to me that the udev being used may be incompatible with our
kernel?
Not sure about this since I use the same distro on my maple and do
not have this problem.
mapled:~ # rpm -qa udev
udev-085-30
I'm not sure how to properly debug this, perhaps you can boot with
"init=/bin/bash" and the from the prompt run:
# /etc/init.d/boot start
that should mount and start up the udevd.
then inspect /dev/ to see if the tty's entries exist.
-JX
_______________________________________________
Xen-ppc-devel mailing list
Xen-ppc-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-ppc-devel
|
|
|
| |
|
Home