Re: [Xen-users] Bridges are not working

[Leopold Palomo Avellaneda <leo@xxxxxxxxxxxx>]

A Divendres 22 Maig 2009, Fajar A. Nugraha va escriure:
> On Fri, May 22, 2009 at 7:57 PM, Leopold Palomo-Avellaneda
>
> <leo@xxxxxxxxxxxx> wrote:
> > Last week I upgrade the debian Lenny and my domU stopped to work
> > (network) and I'm really lost.
>
> Hope you have a backup. It's always a good idea to have tests first
> before implementing them in production.

it's not dramatic, just a bit of time, but I have backup of the important 
things.

> > domU boot, up the interfaces but no network. No packed throw the bridge.
> >
> > my brctl show is:
> >
> > bridge name     bridge id               STP enabled     interfaces
> > eth0            8000.001422757b2c       no              peth0
> > eth1            8000.000423a8b773       no              peth1
> >                                                        vif6.0
>
> Start with the basics :
> - does eth1 work when it's not in a bridge (i.e. before starting xend)

yes, I tested it. I make it work without xend. I have tried with the interface 
down and up, with the same result.

> - does eth1 (the bridge) work when you put ip address there

well, in dom0 it works, with bridge and without bridge, but not in the other 
side of the bridge (domU)

> - is eth1 up

I have tested it with eth1 up and down.

Regards,

Leo

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users