On Thu, 2008-09-18 at 11:29 -0400, James Pifer wrote:
> On Thu, 2008-09-18 at 16:16 +0200, Fabian.Flaegel@xxxxxxxxxxxxx wrote:
> > You can set the mac in the config file.
> >
> > vif = ['mac=...']
> >
> > Will that be enough?
> >
>
> I'm trying to do this but it's not working. I changed this:
> vif=[ '', ]
>
> to:
> vif=['mac=00:08:C7:CA:A4:B2'] and tried vif=['mac=00:08:C7:CA:A4:B2',]
>
> When I start the domU and go to network configuration, I hit delete, and
> then edit it to set it up, yet it still has the old mac address.
>
> How do I get the pv domU to reflect the new mac?
>
> Thanks,
> James
>
Still haven't been able to get the MAC address to change, but I was able
to change eth2 to eth0 following this document as guide:
http://tomclegg.net/xen-eth0-renamed
Wasn't word for word, but somehow my eth2 is now eth0, and now Remedy
finished the installation. Still can't be sure I'm out of the woods yet
though, still getting an error about hostid, which I think is them
trying to determine their hostid for licensing, based on the MAC.
Plus, I still want to figure out how to change the MAC. If I ever
move/migrate the domU to a new host, I'll need to be able to make the
MAC stay the same.
Thanks,
James
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
Home