Re: [Xen-users] missing ethernet device

[Tim Post <tim.post@xxxxxxxxxxxxxxx>]

On Sat, 2007-01-06 at 12:55 +0100, Alessandro R. wrote:
> 2007/1/6, Brock Palen <brockp@xxxxxxxxx>:
> [CUT]
> > 04:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5754
> > Gigabit Ethernet PCI Express (rev 02)
> >          Subsystem: Dell Unknown device 01df
> >          Flags: bus master, fast devsel, latency 0, IRQ 10
> >          Memory at efcf0000 (64-bit, non-prefetchable) [size=64K]
> >          Capabilities: [48] Power Management version 3
> >          Capabilities: [50] Vital Product Data
> >          Capabilities: [58] Vendor Specific Information
> >          Capabilities: [e8] Message Signalled Interrupts: 64bit+
> > Queue=0/0 Enable-
> >          Capabilities: [d0] Express Endpoint IRQ 0
> >
> > What are obvious things i should look for that i would be missing
> > from my config?  Or anything that xen would conflict with?  I am
> > using the xen-3.0.3 downloaded just yesterday.
> >
> 
> The Broadcom NetXtreme BCM5xxx doesn't work with hvm xen :(
> The adapter works for me only in paravirtualized environment.
> 
> I have a pe860 with the same adapter. I have spent 8 days to look for solution
> without success.

You both tried loading forced_eth, right?

Best
--Tim



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users