| |
|
 |
|
 |
|
|
|
| |
|
|
xen-users
Re: [Xen-users] network card
2007/1/3, 80n <80n80n@xxxxxxxxx>:
See below.
[CUT]
Now, the result of a uxdiag -ver command should be: Brd:Rv Bus PCI Spd Base
IRQ MAC FmwVer Configuration
I followed instruction but I have found 2 issue:
The first one: my box doesn't have a Broadcom II netextrime.
Poweredge 860 has a simple broadcom adapter.
I have download the right tool from dell's site
http://support.dell.com/support/downloads/format.aspx?c=us&l=en&s=gen&SystemID=PWE_P4_860&os=DOS&osl=en&deviceid=2957&typecnt=2&libid=5&releaseid=R125872&vercnt=1
The b57udiag is like uxdiag. I try to disable the IPMI with this command:
r:\> b57udiag -c 0 -ipmi 0
after the command I have had this output:
Brd:Rv Bus PCI Spd Base IRQ MAC FmwVer Configuration
1:5708C:B1 04:00:00 PCIE-4 2.5 0xF800 6 00xxxxxxxxxx 1.8.0 auto
The second: I reboot the box, but xen didn't still work; when I ping
from vm to any destination the network fail.
I have always the same situation with arp: in the arp list I find a
incomplete entry for
vm's physical address.
I'm thinking to buy another card and could be more lucky.
--
Alessandro R.
Hp. http://lord2y.lunimig.org
NOTICE
This message is for the named person's use only and it's confidential.
If you receive this message in error, please immediately delete it and
and notify the sender. Thank you.
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
|
|
| |
|
Home