|
|
|
|
|
|
|
|
|
|
xen-users
[Xen-users] only one NIC supported?
After upgrading amd64 from 3.0.0 to 3.0.1 I can only start one bridge.
When trying to manualy start another bridge with:
# ./network-bridge start bridge=xenbr1 netdev=eth1
..I get the following error:
Link veth0 is missing.
This may be because you have reached the limit of the number of interfaces
that the loopback driver supports. If the loopback driver is a module, you
may raise this limit by passing it as a parameter (nloopbacks=<N>); if the
driver is compiled statically into the kernel, then you may set the parameter
using loopback.nloopbacks=<N> on the domain 0 kernel command line.
How do I get my other bridge up? Is it really a lack of loopbacks?
Also, what should xend-config.sxp look like for two NICs bridged? The
documentation is very vague.
Regards,
David
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Xen-users] only one NIC supported?,
David Koski <=
|
|
|
|
|