[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] Serial console problem with Xen 3.0



Hi,

On Wed, 2006-04-05 at 00:40 -0400, Amitayu Das wrote:

> 1. I can boot normal Linux FC4 kernel and direct its output to serial
> console (and see the messages in a separate monitor) using the options
> as mentioned in the grub.conf.
>     If I do the exactly the same (meaning, whatever you can see as
> uncommeted lines in the xen-related portion of the grub.conf),
>     I can't see the messages in the separate monitor.

Right, because you commented out the xen.gz com1=... line, so there's no
HV serial console.  You need that enabled.

> 2. If I uncomment the third line in the following:
> #       kernel /xen.gz dom0_mem=131072 com1=9600,8n1

> then Xen even does not boot up.

I've seen this a lot --- for me, adding "sync_console" to that xen.gz
line cures it.  Does that help for you?

Thanks,
 Stephen



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.