The XEN config option enables the Xen paravirt_ops interface, which is
installed when the kernel finds itself running under Xen. (By some
as-yet fully defined mechanism, implemented in a future patch.)
Xen is no longer a sub-architecture, so the X86_XEN subarch config
option has gone.
The disabled config options are:
- PREEMPT: Xen doesn't support it
- HZ: set to 100Hz for now, to cut down on VCPU context switch rate.
This will be adapted to use tickless later.
- kexec: not yet supported
Signed-off-by: Jeremy Fitzhardinge <jeremy@xxxxxxxxxxxxx>
Signed-off-by: Ian Pratt <ian.pratt@xxxxxxxxxxxxx>
Signed-off-by: Christian Limpach <Christian.Limpach@xxxxxxxxxxxx>
Signed-off-by: Chris Wright <chrisw@xxxxxxxxxxxx>
---
arch/i386/Kconfig | 7 +++++--
arch/i386/Kconfig.debug | 1 +
arch/i386/xen/Kconfig | 10 ++++++++++
kernel/Kconfig.hz | 4 ++--
kernel/Kconfig.preempt | 1 +
5 files changed, 19 insertions(+), 4 deletions(-)
===================================================================
--- a/arch/i386/Kconfig
+++ b/arch/i386/Kconfig
@@ -192,6 +192,8 @@ config PARAVIRT
under a hypervisor, improving performance significantly.
However, when run without a hypervisor the kernel is
theoretically slower. If in doubt, say N.
+
+source "arch/i386/xen/Kconfig"
config ACPI_SRAT
bool
@@ -298,12 +300,12 @@ config X86_UP_IOAPIC
config X86_LOCAL_APIC
bool
- depends on X86_UP_APIC || ((X86_VISWS || SMP) && !X86_VOYAGER) ||
X86_GENERICARCH
+ depends on X86_UP_APIC || (((X86_VISWS || SMP) && !X86_VOYAGER) ||
X86_GENERICARCH)
default y
config X86_IO_APIC
bool
- depends on X86_UP_IOAPIC || (SMP && !(X86_VISWS || X86_VOYAGER)) ||
X86_GENERICARCH
+ depends on X86_UP_IOAPIC || ((SMP && !(X86_VISWS || X86_VOYAGER)) ||
X86_GENERICARCH)
default y
config X86_VISWS_APIC
@@ -743,6 +745,7 @@ source kernel/Kconfig.hz
config KEXEC
bool "kexec system call"
+ depends on !XEN
help
kexec is a system call that implements the ability to shutdown your
current kernel, and to start another kernel. It is like a reboot
===================================================================
--- a/arch/i386/Kconfig.debug
+++ b/arch/i386/Kconfig.debug
@@ -79,6 +79,7 @@ config DOUBLEFAULT
config DOUBLEFAULT
default y
bool "Enable doublefault exception handler" if EMBEDDED
+ depends on !XEN
help
This option allows trapping of rare doublefault exceptions that
would otherwise cause a system to silently reboot. Disabling this
===================================================================
--- /dev/null
+++ b/arch/i386/xen/Kconfig
@@ -0,0 +1,10 @@
+#
+# This Kconfig describes xen options
+#
+
+config XEN
+ bool "Enable support for Xen hypervisor"
+ depends PARAVIRT
+ default y
+ help
+ This is the Linux Xen port.
===================================================================
--- a/kernel/Kconfig.hz
+++ b/kernel/Kconfig.hz
@@ -3,7 +3,7 @@
#
choice
- prompt "Timer frequency"
+ prompt "Timer frequency" if !XEN
default HZ_250
help
Allows the configuration of the timer frequency. It is customary
@@ -49,7 +49,7 @@ endchoice
config HZ
int
- default 100 if HZ_100
+ default 100 if HZ_100 || XEN
default 250 if HZ_250
default 300 if HZ_300
default 1000 if HZ_1000
===================================================================
--- a/kernel/Kconfig.preempt
+++ b/kernel/Kconfig.preempt
@@ -35,6 +35,7 @@ config PREEMPT_VOLUNTARY
config PREEMPT
bool "Preemptible Kernel (Low-Latency Desktop)"
+ depends on !XEN
help
This option reduces the latency of the kernel by making
all kernel code (that is not executing in a critical section)
--
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
|
Home