Re: [Xen-users] no bridge is shown by ifconfig on Xen Debian

[Grant McWilliams <grantmasterflash@xxxxxxxxx>]

On Sat, Apr 10, 2010 at 8:00 AM, Tapas Mishra <mightydreams@xxxxxxxxx> wrote:

I do an ifconfig but at the last of it there is no bridge name
have a look at it I have installed all the things myself.
As Xen wiki page says the default bridge should be xen-br0 in the last
output of ifconfig it is not there
it is Xen-3.2.1 default name of bridge as they are saying should be
the same as default ethernet interface but that is xen-3.3 read point
number 6.So this is not the exact case with me.Where is the difference
occuring.
Here is
http://wiki.xensource.com/xenwiki/XenNetworking

DDDE:~# ifconfig
eth2      Link encap:Ethernet  HWaddr 00:26:b9:82:42:38
         inet addr:192.1.100.12  Bcast:192.1..255  Mask:255.255.0.0
         inet6 addr: fe80::226:b9ff:fe82:4238/64 Scope:Link
         UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
         RX packets:573 errors:0 dropped:0 overruns:0 frame:0
         TX packets:172 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:0
         RX bytes:215986 (210.9 KiB)  TX bytes:20257 (19.7 KiB)



--
Tapas

_______________________________________________

Check the output of brctl show. I'd almost bet your bridge is eth2.

Grant McWilliams

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users