RE: [Xen-users] Hotplugging SCSI device to Windows 2k3 GOS

["Velayudhan, Vinu" <Vinu.Velayudhan@xxxxxxx>]

Hi James,

 

Looks like I am missing something in my test setup.

 

I have tried gplpv_fre_wnet_x86_0.10.0.69.msi. But with these drivers I am not even seeing a hot plug event in Windows GOS when I run the xm scsi-attach in Dom0. With the WinGPLPV-0.9.x, I used to get a hot plug event in Windows.

 

Do I need start any specific component/module in Xen, before hot plugging? I tried this with a Xen 3.3.1 and with fresh Windows GOS image which didn’t had any preinstalled GPL drivers.

 

Thanks,

VinuV

 

 

 

-----Original Message-----
From: James Harper [mailto:james.harper@xxxxxxxxxxxxxxxx]
Sent: Wednesday, July 01, 2009 6:42 PM
To: Velayudhan, Vinu; Xen-users@xxxxxxxxxxxxxxxxxxx
Subject: RE: [Xen-users] Hotplugging SCSI device to Windows 2k3 GOS

 

>

> I am trying to do a scsi hotplug to a Windows GOS using the xm

scsi-attach

> command.

>

> This is my configuration

> RHEL 5.2 DOM0 with Xen 3.3

> 32 bit Windows 2k3 GOS with WindowsXenPV-0.9.4 installed. boot.ini has

/gplpv

> added

 

Try using the 0.10.x series of GPLPV drivers. You'll need to run the

uninstall script before installing.

 

I just tested then and it worked fine under 0.10.x. 0.9.4 may only

support the pre-release version of pvscsi that never made it into xen.

 

James

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users