[Xen-users] SVM windows XP no output on vnc after install

["Albert Wong" <awong.public@xxxxxxxxx>]

Hey guys,

I just installed Xen 3.0.3 on an AMD X2 64-bit.  I've got a pure64 
install of debian booted as the dom0 and am trying to install winXP with 
an HVM setup.

I've gotten the windows XP installer to start and complete (graphics 
running over vnc).  However, when I try to boot XP from the "c" drive, 
after the bios screen, I get a "blank screen" as output from th evnc connection.  Doing an 
xm list shows that the domain is still in boot phase:

Name                     ID Mem(MiB) VCPUs State   Time(s)
Domain-0                  0     1415     2 r-----    595.9
winxp                    22      512     1 -b----      1.3

and xm dmesg has a couple of odd error messages from hvm_vlapic (log 
posted below).  I've tried twiddling with various config entries 
(enabling/disabling apic, acpi, pae), but I get even less far when apic 
and acpi are disabled.

Does anyone have any idea what might be wrong or where to go looking next?

-Albert
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users