Re: [Xen-users] Does xen 3 not compile with vesa support??

[Andrew Turnbull <abturnbull@xxxxxxxxx>]

Hi

On 18/12/05, Mustafa Abbasi <lordverminard@xxxxxxxxx> wrote:
> i think i have finally narrowed down my problem. i think its because the xen
> kernel does not compile with vesa driver support. is this right?? i did
> compile the kernel with vesa support but that one won't even start. it just
> reboot during startup. i have 2 questions
>
> 1. do i need to make an initrd for xen 3 to have vesa support

Yes if you have compiled you kernel with vesa support as M (in menuconfig)

> 2. are the following steps ok to install a good copy of xen with vesa.

not sure but one thing I noticed is

>
> 1. clean install ubuntu breezy.
> 2. install the required dev tools.
> 3 mkdir xen
> 4 cd xen
> 5 tar -xvpzj ../xen-3-testing.tar.gz
> 6 cp ../linux-2.6.12.tar.gz xen3 tsting
> here's where i think the problems can start so please check this
>
> 7 make linux-2.6-xen-config CONFIGMODE=menuconfig (enable the options ) CC=
> gcc-3.4

once you have done a make world to set everything up

you then need to go into the linux ... xen0

an type the following make menu menuconfig ARCH=xen (the ARCH=xen is important)

then cd ..

make clean && make install && make dist (but not make world)

hope that helps

Andrew

> 8 make world CC=gcc-3.4
> 9 sudo make install CC=gcc-3.4
> 10 sudo ./install.sh
> 11 add grub entry
> 12 reboot
>
> or
>
> 7 cp cp /boot/config-2.6.12-9-386 .config
>  8 make linux-2.6-xen-config CONFIGMODE=oldconfig (enable the options ) CC=
> gcc-3.4
>  9 make world CC=gcc-3.4
>  10 sudo make install CC=gcc-3.4
> 11  sudo ./install.sh
> 12  add grub entry
> 13  reboot
>
>
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
>
>

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users