[Xen-devel] [PATCH] Adjust time init sequence

["Tian, Kevin" <kevin.tian@xxxxxxxxx>]

Adjust time init sequence

percpu timer init for BSP happens within init_xen_time,
while CMOS access at end may take up to 1s. This may 
make 1st trigger to calibration timer happens >1s interval
and elapsed local stime for BSP also exceed 1s. However
percpu timer init happens after that point for APs, which
will then have a <1s elapsed local stime at 1st calibration.
That leads to distinct mul_frac among cores, which can
cause up to 6ms system time skew in the start. This is
not big issue, since gradually xen calibration framework
closes that gap. But it's still better to avoid that big 
skew in early boot phase. 

Signed-off-by Kevin Tian <kevin.tian@xxxxxxxxx>

diff -r 85b2f4aafea4 xen/arch/x86/time.c
--- a/xen/arch/x86/time.c       Tue Dec 09 20:56:23 2008 -0500
+++ b/xen/arch/x86/time.c       Tue Dec 09 22:21:07 2008 -0500
@@ -1095,7 +1095,7 @@
 
     local_irq_save(flags);
     rdtscll(t->local_tsc_stamp);
-    now = !plt_src.read_counter ? 0 : read_platform_stime();
+    now = read_platform_stime();
     local_irq_restore(flags);
 
     t->stime_master_stamp = now;
@@ -1118,12 +1118,13 @@
 
     open_softirq(TIME_CALIBRATE_SOFTIRQ, local_time_calibration);
 
-    init_percpu_time();
+    do_settime(get_cmos_time(), 0, 0);
 
     stime_platform_stamp = 0;
     init_platform_timer();
 
-    do_settime(get_cmos_time(), 0, NOW());
+    /* init bsp percpu time after platform timer initialized, similar as AP */
+    init_percpu_time();
 
     return 0;
 }

time_init_seq.patch
Description: time_init_seq.patch

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel