|
|
|
|
|
|
|
|
|
|
xen-devel
[Xen-devel] Question about network-route
Hi,
I saw in file /etc/xen/xend-config.sxp that I also have the choice to use
network-route to configure the network. I have troubles using veth0 so I
would like to give it a shot.
I saw some of instruction given in the mailing list:
http://lists.xensource.com/archives/html/xen-devel/2005-01/msg00368.html
I strictly follow it: modify the xend-config.sxp, configuration script and
start domu. (I didn't change the network-route and vif-route scripts
though)
But it seems that DomU is still trying to get ip from dhcp. It stops at
determine eth0 ip address for quite a long time and quits with fail.
Do I have to change something at /etc/sysconfig/network-script/ifcfg-eth0
in my domU disk image? If so, I guess it should not be booted with dhcp.
But what should my static ip, netmask, default gateway be?
Here I tried to change the static ip to "1.2.3.4" (what ever I specify in
the script) and mask to be 255.255.255.255 but leave the gateway blank.
Now DomU got its ip during boot time cannot connect outside.
I check dom0's route table after domU boots, it seems that 1.2.3.4 is
there:
Kernel IP routing table
tination Gateway Genmask Flags Metric Ref Use Iface
1.2.3.4 * 255.255.255.255 UH 0 0 0 vif1.0
9.2.72.0 * 255.255.255.128 U 0 0 0 eth0
169.254.0.0 * 255.255.0.0 U 0 0 0 eth0
default lab001.watson.i 0.0.0.0 UG 0 0 0 eth0
And DomU's routing table:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
169.254.0.0 * 255.255.0.0 U 0 0 0 eth0
default * 0.0.0.0 U 0 0 0 eth0
Dom0 can ping 1.2.3.4 but cannot ssh. DomU cannot access outside, even use
ping.
Am I miss something here? I really got stuck here so any suggestions will
be helpful.
Thank you very much!
Regards,
Wei Huang
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
|
|
|
|
|