Re: [Xen-devel] [PATCH 5/5 v2] VT-d: adjust IOMMU interrupt affinities when all CPUs are online

[Keir Fraser <keir.xen@xxxxxxxxx>]

On 21/11/2012 12:13, "Jan Beulich" <JBeulich@xxxxxxxx> wrote:

> Since these interrupts get setup before APs get brought online, their
> affinities naturally could only ever point to CPU 0 alone so far.
> Adjust this to include potentially multiple CPUs in the target mask
> (when running in one of the cluster modes), and take into account NUMA
> information (to handle the interrupts on a CPU on the node where the
> respective IOMMU is).
> 
> Signed-off-by: Jan Beulich <jbeulich@xxxxxxxx>

Acked-by: Keir Fraser <keir@xxxxxxx>

> ---
> v2: Call adjust_vtd_irq_affinities() explicitly from enter_state()
>     rather than through acpi_dmar_zap().
> 
> --- a/xen/arch/x86/acpi/power.c
> +++ b/xen/arch/x86/acpi/power.c
> @@ -219,6 +219,7 @@ static int enter_state(u32 state)
>      mtrr_aps_sync_begin();
>      enable_nonboot_cpus();
>      mtrr_aps_sync_end();
> +    adjust_vtd_irq_affinities();
>      acpi_dmar_zap();
>      thaw_domains();
>      system_state = SYS_STATE_active;
> --- a/xen/drivers/passthrough/vtd/iommu.c
> +++ b/xen/drivers/passthrough/vtd/iommu.c
> @@ -1971,6 +1971,33 @@ void clear_fault_bits(struct iommu *iomm
>      spin_unlock_irqrestore(&iommu->register_lock, flags);
>  }
>  
> +static void adjust_irq_affinity(struct acpi_drhd_unit *drhd)
> +{
> +    const struct acpi_rhsa_unit *rhsa = drhd_to_rhsa(drhd);
> +    unsigned int node = rhsa ? pxm_to_node(rhsa->proximity_domain)
> +                             : NUMA_NO_NODE;
> +    const cpumask_t *cpumask = &cpu_online_map;
> +
> +    if ( node < MAX_NUMNODES && node_online(node) &&
> +         cpumask_intersects(&node_to_cpumask(node), cpumask) )
> +        cpumask = &node_to_cpumask(node);
> +    dma_msi_set_affinity(irq_to_desc(drhd->iommu->msi.irq), cpumask);
> +}
> +
> +int adjust_vtd_irq_affinities(void)
> +{
> +    struct acpi_drhd_unit *drhd;
> +
> +    if ( !iommu_enabled )
> +        return 0;
> +
> +    for_each_drhd_unit ( drhd )
> +        adjust_irq_affinity(drhd);
> +
> +    return 0;
> +}
> +__initcall(adjust_vtd_irq_affinities);
> +
>  static int init_vtd_hw(void)
>  {
>      struct acpi_drhd_unit *drhd;
> @@ -1984,13 +2011,10 @@ static int init_vtd_hw(void)
>       */
>      for_each_drhd_unit ( drhd )
>      {
> -        struct irq_desc *desc;
> +        adjust_irq_affinity(drhd);
>  
>          iommu = drhd->iommu;
>  
> -        desc = irq_to_desc(iommu->msi.irq);
> -        dma_msi_set_affinity(desc, desc->arch.cpu_mask);
> -
>          clear_fault_bits(iommu);
>  
>          spin_lock_irqsave(&iommu->register_lock, flags);
> --- a/xen/include/xen/iommu.h
> +++ b/xen/include/xen/iommu.h
> @@ -137,6 +137,9 @@ int iommu_do_domctl(struct xen_domctl *,
>  void iommu_iotlb_flush(struct domain *d, unsigned long gfn, unsigned int
> page_count);
>  void iommu_iotlb_flush_all(struct domain *d);
>  
> +/* While VT-d specific, this must get declared in a generic header. */
> +int adjust_vtd_irq_affinities(void);
> +
>  /*
>   * The purpose of the iommu_dont_flush_iotlb optional cpu flag is to
>   * avoid unecessary iotlb_flush in the low level IOMMU code.
> 
> 
> 



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel