[Xen-users] errors when xend starts

[ShaunR <mailinglists@xxxxxxxxxxxxxxxx>]

When starting xend i see the following errors on the console.  I'm 
running CentOS 5 as the operating system with kernel 2.6.32.18 from 
4.0.1's `make prep-kernels`
Below is a log, the things i'm concerned with is the XENBUS errors and 
the deprecated iptables stuff.  Any ideas whats going on here?
----------------------------------------------------
Bridge firewalling registered
ADDRCONF(NETDEV_UP): peth0: link is not ready
igb: peth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX
ADDRCONF(NETDEV_CHANGE): peth0: link becomes ready
device peth0 entered promiscuous mode
eth0: port 1(peth0) entering forwarding state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
XENBUS: Unable to read cpu state
peth0: no IPv6 routers present
eth0: no IPv6 routers present
device vif1.0 entered promiscuous mode
eth0: port 2(vif1.0) entering forwarding state
ip_tables: (C) 2000-2006 Netfilter Core Team
nf_conntrack version 0.5.0 (8024 buckets, 32096 max)
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use
nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
physdev match: using --physdev-out in the OUTPUT, FORWARD and 
POSTROUTING chains for non-bridged traffic is not supported anymore.
----------------------------------------------------


~ShaunR


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users