Re: [XEN-USERS] Windows GPLPV 0.9.2 & "add new hardware" -> BSOD

["Barry BURNEREAU" <bburnereau@xxxxxxxx>]

One more information:
I've tested once again. My dom0 is still ok today (it only takes a very long time to destroy the domu)

Barry

2008/6/10 Barry BURNEREAU <bburnereau@xxxxxxxx>:

2008/6/10 James Harper <james.harper@xxxxxxxxxxxxxxxx>:

> Hello
>
> I have a windows 2003 (not 64bit) running on a xen 3.2.0 (debian with
> backport). I've install gplpv driver 0.9.2 and everything works fine.
But
> yesterday, I try to add a Microsoft loopback network card, and I
obtain a
> BSOD.
> This BSOD occured when the os search for new hardware, after I use
> Control Panel -> Add new hardware. I click next, and then BSOD. (I use
> french Windows version, so, some of my translation could not be
> appropriate)
>
> Does somebdoy have the same trouble ? I finally add the LoopBack
network
> card by rebooting without GPLPV enable.
>
> I cannot install the last version to test it right now, but if
somebody
> could try ...
>

Later versions definitely have better support for driver stopping and
removing, so I'd hope that the later versions work.

Can you give me the details of the BSoD?

thanks

James

Hi James

This is the detail of the BSOD:
Plug and Play has detected an error probably due to an incorrect driver
STOP: 0x000000CA (0x00000005,0x89DA4AB8,0x00000000, 0x00000000)

After that, my Dom0 is quite unstable. I could not destroy the vm which have crash. I could even not cleanly reboot my dom0.

Barry

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users