Re: [Xen-users] Various Problems on dom0 Compilation

[Stephen Yum <steveyum@xxxxxxxxxxxxxx>]

Yeah, I used to get this a lot. I have a 29160 on one of my systems  
and I always set up raids on them.
When compiling the kernel, I recommend that you statically build in  
the drivers for adaptec (AIC7xxxx, I believe), as well as RAID, RAID0  
and RAID1.
Then whether you run a initrd or not, you should be able to boot up  
and have your kernel recognize and mount the root drive.
S


On May 28, 2006, at 2:16 PM, eorellan@xxxxxxxxxxxxxxxxxxx wrote:

> Hi everyone.
>
>    I have some problems every time i compile the kernel for xen dom0.
>
> First at all, every the time i need to do the make menuconfig to  
> change
> the CPU detected con .config file, because always says i have an AMD
> Opteron, but the true is i have an Intel Pentium D 830 CPU (something
> weird at all).
>
> Then i save the new .config and i when i set 'make world
> XEN_COMPILE_ARCH=x86_32' apears some questions about .config needed
> parameters, not found in .config file. (another weird thing).
>
> The last problem is when i install the new kernel for dom0, always  
> goes to
> panic, the boot device is an md (linux software) RAID 1 over 2 SCSI  
> hard
> disc 18GB quantum, attached over an Adaptec 29160.
>
> every time apears on tty0 : PANIC, UNABLE TO MOUNT bla bla bla bla...
>
> then reboots the xen dom0..
>
> some ideas???
>
> Edgar Díaz.
> Xen newbie...
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users