Hi James,
Many thanks for your quick reply, and for the help. I'm now able to
see the dom0 machine from the network, but I can't seem to get into our
out of dom1. I can't see any IP addresses on my network such as
192.168.1.10 from within dom1, nor can I ping the machine's address from
dom0 or elsewhere on the network.
My dom1 is a just a copy of the partition of the root partition of
Suse9.2 used for dom0
In my domain configuation file for dom1, I've tried the following for
the vif:
1) vif= ['mac=00:xx:xx:xx:xx:xx, bridge=xen-br0']
2) vif= ['mac=00:xx:xx:xx:xx:xx, bridge=xen-br0, ip=192.168.1.25']
3) vif = ['bridge=xen-br0']
4) nothing (commented out)
In dom0, the eth0, vif, and xen-br0 interface are all up and running.
After fooling around with other options, I removed the eth0 interface
from my domU, which seems to have been a bad idea, because now I'm not
sure what module to use for an eth0 device. Prior to this, I noticed
that there was no xen-br0 device in dom1, just dom0.
Any ideas?
Thanks,
Eric
James Bulpin wrote:
Eric,
Use yast, or your favourite firewall configurator, to add a custom named
interface of "xen-br0" to the same security zone as eth0.
If that doesn't do the trick, please post the output of the following
command in dom0:
iptables -v -L
iptables -v -L -t nat
James
On Tue, 2005-05-17 at 23:08, Eric E wrote:
Hi all,
I'm just getting started with Xen, and having some problems with
networking. I installed Xen 2.0.5 from the Suse 9.2 binaries, and
have been able to boot a domain fine. I'm hoping to make two domains
and give them static IP addresses (e.g. 192.168.1.25 and
192.168.1.26) - nothing fancy.
When I start the xend service, however, xen's network script deletes all
routes associated with eth0, and associates them with xen-br0.
Thereafter I cannot ping or ssh to the machine from any external
machines. My attempts to delete and recreate routes:
route del -net 192.168.1.0 netmask 255.255.255.0
route add -net 192.168.1.0 netmask 255.255.255.0 eth0
route del default gw 192.168.1.1
route add default gw 192.168.1.1 eth0
have been ineffective so far. When I run the xen network script:
network stop bridge=xen-br0 netdev=eth0
I get connectivity back.
Does anyone have any recommendations for quickly setting up my
routing/bridging to make my two virtual domains available form my
network?
Thanks,
Eric
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
Home