>>> On 11.11.11 at 18:13, Andrew Cooper <andrew.cooper3@xxxxxxxxxx> wrote:
> On 11/11/11 16:00, Jan Beulich wrote:
>> Following the prevention of vector sharing for MSIs, this change
>> enforces the same within IO-APICs: Pin based interrupts use the IO-APIC
>> as their identifying device under the AMD IOMMU (and just like for
>> MSIs, only the identifying device is used to remap interrupts here,
>> with no regard to an interrupt's destination).
>>
>> Additionally, LAPIC initiated EOIs (for level triggered interrupts) too
>> use only the vector for identifying which interrupts to end. While this
>> generally causes no significant problem (at worst an interrupt would be
>> re-raised without a new interrupt event actually having occurred)
>
> At worst, hardware asserts a line interrupt, deasserts it later, and an
> EOI broadcast gets rid of any record that the IRQ was ever raised.
> While I would classify this as buggy behavior, I believe I have seen
> some hardware doing this when investigating the line level IRQ migration
> bug, as clearing the IRR did not immediately cause another interrupt to
> be generated.
>
>> , it
>> still seems better to avoid the situation.
>>
>> For this second aspect, a distinction is being made between the
>> traditional and the directed-EOI cases: In the former, vectors should
>> not be shared throughout all IO-APICs in the system, while in the
>> latter case only individual IO-APICs need to be contrained (or, if the
>> firmware indicates so, sub- groups of them having the same GSI appear
>> at multiple pins).
>>
>> Signed-off-by: Jan Beulich <jbeulich@xxxxxxxx>
>
> Provisional nack because it is my understanding that under all
> circumstances, you must maintain a vector exclusivity map across all
> IO-APICs because of the broadcast problem. Or have I made a mistake in
> my reasoning?
With directed EOI there's no broadcasting involved, which is why
global sharing prevention is not necessary.
However, after some more thinking over the weekend I think we need
to also/first adjust end_level_ioapic_irq()'s call to io_apic_eoi_vector():
It shouldn't really iterate over all IO-APICs, but instead call
eoi_IO_APIC_irq(). Thoughts? (That would also eliminate the need to
look up pin or vector in __io_apic_eoi(), as all remaining call sites pass
both.)
Jan
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
|
Home