Re: [Xen-devel] AMD Phenom II 940: mm/vmalloc.c:110 vmap_page_range_noflush

[Gerry Reno <greno@xxxxxxxxxxx>]

On 05/06/2010 08:21 PM, Gerry Reno wrote:
> Ok, I tested with the new 2.6.32.12:  (.config same)
>
> Case 1:  Xen 4.0.0-rc8 / pv_ops dom0 kernel 2.6.32.12
>
> Still pv_ops dom0 is not working properly.
> There are still call trace and other errors.  The kernel does boot up 
> but it takes again a long time to get the login prompt (about 3 
> mins).  This is far longer than when I used 2.6.31.6 pv_ops dom0.  
> Networking does not start properly (only see 'lo' and 'virbr0'), so I 
> have to restart it manually and then I see my bridge 'br0' and 'eth0'.
> Can't find device "br0"
> /etc/xen/scripts/network-bridge: line 240: "sigerr" command not found.
> And it is trying unsuccessfully to start some laptop feature like 
> S99powernap (unknown job) and also S28-libvirt-bin fails (maybe 
> network related?).
> Case 2:  pv_ops domU kernel 2.6.32.12  (no xen dom0):
>
> Now the straight linux kernel (no xen dom0) boots right up and goes to 
> login prompt in normal timeframe.  Networking starts correctly.  
> Things look pretty normal.
> Observation:
> I'm getting slightly different output on console and serial console.  
> Some errors show on one but not the other.  Shouldn't these be identical?
> I'm attaching both serial console outputs.
>
> menu.lst is same as before (just .12 instead of .10)
>
> -Gerry
And I'm attaching the syslog from Case 1 (pv_ops dom0).

-Gerry

syslog
Description: Text document

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel