Re: [Xen-devel] Re: console changes in cs153 on 2.6.18-xen

[Stefan Berger <stefanb@xxxxxxxxxx>]

Keir Fraser <Keir.Fraser@xxxxxxxxxxxx> wrote
on 09/07/2007 01:21:16 PM:

> Oh, you want output on the vga console? Then console=tty0 should 
> still work fine, as it always has. The xenconsole changes shouldn’t
> have affected vga output by dom0 at all.

Something broke tty0 and I reverted CS153 and it solves
the problem for me. If I pass console=tty0 in the domain-0 boot command
line now on CS195 then the last output I see is 'Continuing...' after the
'big' tls emulation warning. Not even a prompt anymore, but some kernel
error message -- a different note for these error messages, though.

   Stefan

> 
>  -- Keir
> 
> On 7/9/07 17:12, "Stefan Berger" <stefanb@xxxxxxxxxx>
wrote:

> > Remove console=ttyS0 from your command line,
if you have it. You can
> > replace it with console=xvc0. 
> 
> I actually had console=tty0 on my machines before and this worked
> fine. Now using console=xvc0 I see the (Xen) outputs with the last
> line that Xen is relinquishing the VGA console and then no output
> during the boot process. The blinking cursor moves into the upper
> left corner after Xen is done and at some point during the boot 
> process the Xen output becomes mouse-selectable. Then comes the 
> login prompt. I am surprise that no one else seeing this.
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel