Hi Markus,
I checked that the result of conversion had passed PVFB and gone out of
fbflont.
I think that the conversion by the OS side will go wrong.
If you know how it will pass from guest OS to guest OS's X,
please give me some comments.
When I input "\", following message a display each modules
PVFB:
keycode 92(0x5C) -> scancode 115
xev:
keycode 176 keysym 0x0, NoSymbol
Thanks,
-
Junko Ichino
----- Original Message -----
From: "Markus Armbruster" <armbru@xxxxxxxxxx>
To: "Junko Ichino" <ichino.junko@xxxxxxxxxxxxxx>
Cc: <Xen-devel@xxxxxxxxxxxxxxxxxxx>
Sent: Friday, January 12, 2007 2:54 AM
Subject: Re: [Xen-devel] [RFC] keymap support for PVFB
"Junko Ichino" <ichino.junko@xxxxxxxxxxxxxx> writes:
Hi Markus,
Thank you for your reply.
The key that doesn't work is \, | , _ , arrow (UP, DOWN, LEFT, and
RIGHT),
Hankaku/Zenkaku , Muhenkan , Katakana/Hiragana and so on.
(When you do not know about Hankaku/Zenkaku etc., please question the
Japanese
who is in near.)
When I looked at atkbd.c, it seemed to change scancode again.
I put in the same conversion immediately after changing into scancode
from keysym by PVFB.
However, it failed.
I investigate this problem continuously.
How can we help?
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
|
Home