Hello
David,
I reply your by sending to Xen-devel because of your
mail address
isn't usable. I can't
reply directly to you because of the following
error:
Your message was not
delivered to: dfbp@xxxxxxxxxx
because: Enhanced Mail System
Status Code (RFC1893): 5.1.2
Here the /etc/fstab file of my
Fedora Core 2 :
/dev/hda8
/ ext3
defaults 1 1
/dev/hda9
swap swap defaults
0 0
none /dev/pts devpts
gid=5,mode=620 0 0
none /dev/shm tmpfs
defaults 0 0
none /proc
proc defaults 0 0
none
/sys sysfs defaults
0 0
And the Xen
configuration file used to start the domain:
kernel =
"/boot/vmlinuz-2.6.9-xenU"
memory =
64
disk = [ 'phy:/dev/hda8,hda8,w',
'phy:/dev/hda9,hda9,w' ]
root =
"/dev/hda8"
I think it's
correct.
Thanks for your help
and have a good year.
------------------------------------------------------------------------------------------------
In response
to:
From: Philippe
Berthault [Philippe.Berthault@xxxxxxxx]
To:
Xen-Devel
I'm unable to start
Linux Fedora Core 2 in a user domain, with the vmlinuz-2.6.9-xenU
kernel
image delivered with xen-2.0.1-install.tgz.
The boot aborts with
the following message:
/sbin/init:
error while loading shared libraries:
libselinux.so.1:
cannot dynamically load
executable
Kernel panic - not syncing: Attempted to kill init
!
I dont understand
because the libselinux.so.1 is present on the Fedora Core 2 system. The
problem isn't in relation with the presence of this
library.
------------------------------------------------------------------------------------------------
From: David F
Barrera [dfbp@xxxxxxxxxx]
Make sure /etc/fstab
on the xenU partition has /dev/sda1 (or whatever your xen config file
has
set as root device). Let me know if this works.
David
------------------------------------------------------------------------------------------------