Hi,
I am new to Xen, I get the following message when
trying to create domain using xen-2.0 built on RedHat 9/ Pentium PC with IDE
drive:
“Kernel
panic: No init found. Try passing init= option
to kernel”.
Below is console dump. Any
suggestions ?
Thanks
[root@mppunami-linux xen]#
xm console 35
************ REMOTE CONSOLE:
CTRL-] TO QUIT ********
Linux version 2.6.8.1-xenU
(mpunamia@mppunami-linux)
(gcc version 3.2.2 20030222
(Red
Hat Linux 3.2.2-5)) #1 Fri
Sep 24 12:18:12 PDT 2004
BIOS-provided physical RAM
map:
Xen: 0000000000000000
- 0000000004000000 (usable)
64MB LOWMEM available.
DMI not present.
Built 1 zonelists
Kernel command line:
ip=dhcp root=/dev/hda1 ro 4
Initializing CPU#0
PID hash table entries: 512
(order 9: 4096 bytes)
Xen reported: 1794.224 MHz
processor.
Using tsc for high-res
timesource
Dentry cache hash table
entries: 16384 (order: 4,
65536 bytes)
Inode-cache hash table
entries: 8192 (order: 3, 32768
bytes)
Memory: 62444k/65536k
available (1548k kernel code,
3004k reserved, 458k data,
92k init, 0k highmem)
Checking if this processor
honours the WP bit even in
supervisor mode... Ok.
Calibrating delay loop...
1776.02 BogoMIPS
Mount-cache hash table
entries: 512 (order: 0, 4096
bytes)
CPU: Trace cache: 12K uops, L1
D cache: 8K
CPU: L2 cache: 256K
CPU: Intel(R) Pentium(R) 4
CPU 1.80GHz stepping 02
Enabling unmasked SIMD FPU
exception support... done.
Checking 'hlt'
instruction... disabled
NET: Registered protocol
family 16
Initializing Cryptographic
API
RAMDISK driver initialized:
16 RAM disks of 4096K size
1024 blocksize
Xen virtual console
successfully installed as tty
Event-channel device
installed.
Initialising Xen virtual
block device
Using anticipatory io
scheduler
Initialising Xen virtual
ethernet frontend driver.
Netfront recovered tx=0
rxfree=0
NET: Registered protocol
family 2
IP: routing cache hash table
of 512 buckets, 4Kbytes
TCP: Hash tables configured
(established 4096 bind
8192)
NET: Registered protocol
family 1
NET: Registered protocol
family 17
IP-Config: Guessing netmask
255.0.0.0
IP-Config: Complete:
device=eth0, addr=62.0.0.0, mask=255.0.0.0,
gw=255.255.255.255,
host=62.0.0.0, domain=, nis-domain=(none),
bootserver=255.255.255.255,
rootserver=255.255.255.255,
rootpath=
kjournald starting.
Commit interval 5 seconds
EXT3-fs warning (device
hda1): ext3_clear_journal_err:
Filesystem error recorded
from
previous mount: IO failure
EXT3-fs warning (device
hda1): ext3_clear_journal_err:
Marking fs in need of
filesystem check.
EXT3-fs: mounted filesystem
with ordered data mode.
VFS: Mounted root (ext3
filesystem) readonly.
Freeing unused kernel
memory: 92k freed
Warning: unable to open an
initial console.
Kernel panic: No init
found. Try passing init= option
to kernel.
Home