On Mon, Aug 1, 2011 at 10:56 AM, Walter <ditwal001@xxxxxxxxx> wrote:
> you might see if a process is attached with lsof | grep IPv4 and kill it,
> /etc/init.d/xend restart
>
>
> thanks walter
>
>
>
> On 01.08.2011, at 19:35, Simon Hobson <linux@xxxxxxxxxxxxxxxx> wrote:
>
>> Matt Richardson wrote:
>>
>>> I use the same set up as Walter. The configuration is complicated
>>> enough that making a change in the interfaces file requires a restart,
>>> restarting networking isn't enough. Could be that I just don't know
>>> the magic to make it happen without a restart. Anyway, I have a
>>> couple of servers with multiple interfaces, with each interface having
>>> its own bridge entry which works very well.
>>
>> I find it's more reliable if you remember to bring an interface down before
>> altering it, and then bring it back up. Obviously you have a problem if
>> there are guests attached to a bridge when you try to remove it - could that
>> be your problem ?
>>
>> --
>> Simon Hobson
>>
Thanks for the tips, I'll try it on the next system I bring up. It's
usually only an issue when I install from scratch, so I haven't spent
much time working it out. I get the bridge attached to eth0 before
installing any VMs and once it's set I don't usually have to touch it,
but Simon raises a good point that I'll keep in mind next time I do
have to mess with it.
--
Matt
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
Home