| |
|
 |
|
 |
|
|
|
| |
|
|
xen-users
Re: [Xen-users] blank screen after xen boot
On 06/16/2011 07:20 PM, Todd Deshane wrote:
On Thu, Jun 16, 2011 at 7:24 PM, Mike Wright<mike.wright@xxxxxxxxxxxxxx> wrote:
Hi all,
New to the world of linux-3.0.0 and very excited.
xen-4.1.1 compiles and installs without complaint.
linux-3.0.0-rc3 from kernel.org also compiles without complaint.
On boot I see the [XEN] hypervisor booting, the screen flickers to black
then a dark grey and the system just sits there unresponsive.
Any ideas where to go from here?
You might want to try Konrad's branch for now:
http://git.kernel.org/?p=linux/kernel/git/konrad/xen.git
There may be some patches that have not been merged yet that apply to
your situation. For example, I believe some VGA stuff will not make it
into the kernel until 3.1
Thanks, Todd.
Pulled and built that kernel and it boots standalone; however it
segfaults when used with xen.gz. At least I see the segfault so that's
a definite improvement :/
If that kernel doesn't work for you, then use the suggestions on this
page to maximize xen and kernel output and post all relevant logs to
the xen-devel mailing list.
Can you expand on the above paragraph? I don't understand which page
you're referring to.
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
|
|
| |
|
Home