Re: [Xen-users] trouble installing

[Ted Brenner <griztown@xxxxxxxxx>]

Yes, I had.  I know it's hard to believe but this stuff isn't as obvious to everyone.  Here's what the wiki says:

This will add the two interfaces eth0 and eth1 to bridge br0. Simple enough. There’s no distinction with how you add the bridges, or what order you do it, or any special commands you have to add to distinguish them. So don’t worry about that.

Well, now we have our bridges, so bring all the interfaces up, and you’ll be set! 

The next part, which addresses the interface, makes it sound like you do that if you want it to work at boot but I couldn't get it to work at all so I didn't think I was at that stage yet.  Anyway, clearly a misunderstanding.  I think I also don't understand what it means to "bring all the interfaces up" but now I think I do.

I do appreciate the help, thanks for taking the time.
Ted

On Wed, Feb 23, 2011 at 7:42 AM, Fajar A. Nugraha <list@xxxxxxxxx> wrote:

On Wed, Feb 23, 2011 at 8:38 PM, Ted Brenner <griztown@xxxxxxxxx> wrote:
> Thanks Fajar and Pasi,
>
> I'm not sure how to add my IP to the bridge.  It tells me 10.0.0.3 is not an
> interface.  I'm sorry if I don't know much about networking.
>
> Here's my /etc/network/interface
>
> # more /etc/network/interfaces
> # This file describes the network interfaces available on your system
> # and how to activate them. For more information, see interfaces(5).
>
> # The loopback network interface
> auto lo
> iface lo inet loopback
>
> # The primary network interface
> allow-hotplug eth0
> #NetworkManager#iface eth0 inet dhcp

That's it? No mention about br0 whatsoever on /etc/network/interfaces?

Then start by following the example /etc/network/interfaces on the
debian wiki. It should be clear enough. You HAVE, read the wiki page,
right?

--
Fajar

-- 
Ted Brenner
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users