xen-users

[Top] [All Lists]

[Xen-users] help with bridging

from [Tino]

[Permanent Link][Original]

To:	xen-users@xxxxxxxxxxxxxxxxxxx
Subject:	[Xen-users] help with bridging
From:	Tino <tino@xxxxxxxxxxxxxxxx>
Date:	Fri, 12 Nov 2010 18:51:58 +0530
Delivery-date:	Fri, 12 Nov 2010 05:22:58 -0800
Envelope-to:	www-data@xxxxxxxxxxxxxxxxxxx
List-help:	<mailto:xen-users-request@lists.xensource.com?subject=help>
List-id:	Xen user discussion <xen-users.lists.xensource.com>
List-post:	<mailto:xen-users@lists.xensource.com>
List-subscribe:	<http://lists.xensource.com/mailman/listinfo/xen-users>, <mailto:xen-users-request@lists.xensource.com?subject=subscribe>
List-unsubscribe:	<http://lists.xensource.com/mailman/listinfo/xen-users>, <mailto:xen-users-request@lists.xensource.com?subject=unsubscribe>
Sender:	xen-users-bounces@xxxxxxxxxxxxxxxxxxx

Hello,

There is a xen setup in which "brctl show" gives the following output.

bridge name     bridge id               STP enabled     interfaces
eth1            8000.003048c9d4df       no               peth1
                                                        vif1.0
                                                        vif2.0
                                                        vif3.0

No other bridge is present there.
That means the bridge is eth1, but network configuration for one of the vms looks like the following in the configuration file

Networking
#
vif         = [
        'ip=192.168.1.158,mac=00:16:3E:19:26:71,bridge=xenbr1'
]

But there is no network interface like xenbr1 when you type ifconfig .
This setup is working fine. I am not sure how this works. I am new to xen, so if anybody help me to understand this setup.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
[Xen-users] help with bridging, Tino <= Re: [Xen-users] help with bridging, Todd Deshane Re: [Xen-users] help with bridging, Mark Pryor Re: [Xen-users] help with bridging, Tino Re: [Xen-users] help with bridging, Todd Deshane Re: [Xen-users] help with bridging, Tino Re: [Xen-users] help with bridging, Todd Deshane

Previous by Date:	Re: [Xen-devel] xen guest not booting, Stefano Stabellini
Next by Date:	Re: [Xen-users] Opinion on best way to use network storage, Jorge Viana
Previous by Thread:	[Xen-users] Xend has probably crashed! Invalid or missing HTTP status code., jayesh shinde
Next by Thread:	Re: [Xen-users] help with bridging, Todd Deshane
Indexes:	[Date] [Thread] [Top] [All Lists]