RE: [Xen-API] XCP - ddk network

[Dave Scott <Dave.Scott@xxxxxxxxxxxxx>]

Hi Sergio,

 

Since it shows ‘currently-attached=true’ the guest must have an vif inside it. Does ‘ifconfig eth0’ inside the guest look ok? If that’s fine then it suggests the packets are getting lost somewhere – I think you’ll have to debug it with tcpdump.

 

Cheers,

Dave

 

From: Sergio Charpinel Jr. [mailto:sergiocharpinel@xxxxxxxxx]
Sent: 13 July 2010 21:27
To: Dave Scott
Cc: xen-users@xxxxxxxxxxxxxxxxxxx; xen-api@xxxxxxxxxxxxxxxxxxx
Subject: Re: [Xen-API] XCP - ddk network

 

Dave,

 

uuid ( RO)                        : 558dcfdb-9edf-e9cb-a203-9666d9d955e4

                     vm-uuid ( RO): fceed081-ffca-6057-7cc8-35a9e5ad7d76

               vm-name-label ( RO): buildvm

          allowed-operations (SRO): attach; unplug

          current-operations (SRO): 

                      device ( RO): 0

                         MAC ( RO): ee:56:a1:5e:59:03

           MAC-autogenerated ( RO): true

                         MTU ( RO): 1500

          currently-attached ( RO): true

          qos_algorithm_type ( RW): 

        qos_algorithm_params (MRW): 

    qos_supported_algorithms (SRO): 

                other-config (MRW): 

                network-uuid ( RO): 1b4e6c7a-5aeb-120b-5888-4663f3af479c

          network-name-label ( RO): Pool-wide network associated with eth0

                 io_read_kbs ( RO): <expensive field>

                io_write_kbs ( RO): <expensive field>

 

I've set IP to domU. But I just can ping dom0 IP.

 

2010/7/13 Dave Scott <Dave.Scott@xxxxxxxxxxxxx>

Hi Sergio,

 

Could you show the output of

 

xe vif-list vm-uuid=<your VM uuid> params=all

 

There should be a VIF object linking the specific VM to the specific Network. Once that’s plugged in (either ‘xe vm-reboot’/’xe vm-start’ or ‘xe vbd-plug’) then inside the guest you can configure the IP address.

 

Cheers,

Dave

 

 

From: xen-api-bounces@xxxxxxxxxxxxxxxxxxx [mailto:xen-api-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Sergio Charpinel Jr.
Sent: 13 July 2010 20:23
To: xen-users@xxxxxxxxxxxxxxxxxxx; xen-api@xxxxxxxxxxxxxxxxxxx
Subject: [Xen-API] XCP - ddk network

 

Hi,

 

I've installed XCP 0.5 and I'm following these steps: http://xenbits.xen.org/xapi/install.html to install ddk VM. But I can't get network working.

I tried to create a vif under xenbr0 then assigned mannually a IP address and to create a vif under xapi0. But in both cases I can ping only dom0 IP.

 

What am I doing wrong?

 

Thanks in advance.

--
Sergio Roberto Charpinel Jr.

--
Sergio Roberto Charpinel Jr.

_______________________________________________
xen-api mailing list
xen-api@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/mailman/listinfo/xen-api