[Xen-users] [XCP] XCP 0.5RC2 - bug with memory target

[George Shuklin <nge@xxxxxxxx>]

I found a strange behavior (i think, this is bug).

Summary: it is not possible to change target memory for PV guest lager, than 
was at moment of startup.

Steps to reproduce:

1) Create and install PV test VM (in my case this is debian lenny 
2.6.32-4-686-bigmem), shutdown it.
2) Set memory limits: xe vm-memory-static-range-set vm=test min=100Mb max=2GiB
3) Set target: xe vm-memory-target-set vm=test target=300MiB
4) Startup and boot test VM
5) try to lower target: xe vm-memory-target-set vm=test target=200MiB (all ok, 
it works)
6) try to raise target: xe vm-memory-target-set vm=test traget=400MiB (here: no 
error dynamic_min/dynamic_max changing, but real memory does not raise over 
initial value)

I can freely move memory in range [static-min;target_at_boot], but I can not 
set any values in range [target_at_boot;static-max].

I test it with vm-memory-dynamic-set - same behavior.

If someone confirm this bug, I'll open it in bugzilla.

-- 
wBR,George.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users