 Home |
Products |
Support |
Community |
News |
xen-users
[Xen-users] How to make bridge with no IP
| To: | Xen-users@xxxxxxxxxxxxxxxxxxx |
|---|---|
| Subject: | [Xen-users] How to make bridge with no IP |
| From: | Jonathan Tripathy <jonnyt@xxxxxxxxxxx> |
| Date: | Tue, 08 Jun 2010 20:35:47 +0100 |
| Cc: | |
| Delivery-date: | Tue, 08 Jun 2010 12:36:56 -0700 |
| Envelope-to: | www-data@xxxxxxxxxxxxxxxxxxx |
| List-help: | <mailto:xen-users-request@lists.xensource.com?subject=help> |
| List-id: | Xen user discussion <xen-users.lists.xensource.com> |
| List-post: | <mailto:xen-users@lists.xensource.com> |
| List-subscribe: | <http://lists.xensource.com/mailman/listinfo/xen-users>, <mailto:xen-users-request@lists.xensource.com?subject=subscribe> |
| List-unsubscribe: | <http://lists.xensource.com/mailman/listinfo/xen-users>, <mailto:xen-users-request@lists.xensource.com?subject=unsubscribe> |
| Sender: | xen-users-bounces@xxxxxxxxxxxxxxxxxxx |
| User-agent: | Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.9.1.9) Gecko/20100423 Thunderbird/3.0.4 |
Hi Everyone,I wish to make a bridge in my Dom0 that has no IP address assigned to it. By default, Xen attaches my peth0 interface to a bridge called eth0. I then have a firewall DomU with a network interface which is connected to the eth0 bridge. The problem is, is that the setup only works if eth0 in the Dom0 has an ip. If I do ifdown eth0 to remove the IP, the bridge stops working. Any ideas? Thanks _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Xen-users] Non-pvops kernel, 0bo0 |
|---|---|
| Next by Date: | RE: [Xen-users] Problems with GPLPV network latency, Ian Tobin |
| Previous by Thread: | [Xen-users] Non-pvops kernel, Jonathan Tripathy |
| Next by Thread: | Re: [Xen-users] How to make bridge with no IP, Simon Hobson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
