I think the problem has something to do with NetworkManager since I
noticed rebooting the machine many times that after bringing eth0 and
eth1 up when NetworkManager daemon starts the machine is not able to
reply to ICMP Echo while
the machine brings eth0 up it starts replying till the time
NetworkManager is not on
but to my surprise I have disabled the Network Manager
just see the output here
[root@localhost ~]# chkconfig NetworkManager --list
NetworkManager 0:off 1:off 2:on 3:on 4:on 5:on 6:off
On Tue, Dec 1, 2009 at 9:38 PM, Tapas Mishra <tapas@xxxxxxxxxxxx> wrote:
> Hmmm well what is happening here is that right now before you mailed I
> just rebooted the concerned machine and on the other machine when the
> target machine came up for some seconds I was able to see the reply of
> Xen machine and once the gnome display came everything is a mess as I
> report here in thread.
>
> On Tue, Dec 1, 2009 at 8:04 AM, Paolo <paolovictor@xxxxxxxxx> wrote:
>> I had a similar problem a couple days ago. I had this network layout:
>>
>> DHCP Server <-> Switch <-> Host
>>
>> Somehow, I could ssh from the DHCP server to a DomU at the host, but
>> not on the other way around. A friend of mine suggested checking the
>> routing table at the Host's Dom0, and it was:
>>
>> root@aramis:~# route -n
>> Kernel IP routing table
>> Destination Gateway Genmask Flags Metric Ref Use Iface
>> 10.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
>> 0.0.0.0 10.0.0.1 0.0.0.0 UG 100 0 0 eth0
>> 10.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 peth0
>> 0.0.0.0 10.0.0.1 0.0.0.0 UG 100 0 0 peth0
>>
>> Where 10.0.0.1 is the DHCP server's IP address. eth0 is the host's
>> network interface that's connected to the switch.
>>
>> It seemed strange, so I've started toying around and deleted the
>> entries for the peth0:
>>
>> route del -net 0.0.0.0 dev peth0
>> route del -net 10.0.0.0 dev peth0
>>
>> And lo and behold, now the DomU could access the Internet (ping
>> google, etc). Thinking of it now, I didn't remove/disable the network
>> managers (I'm using Ubuntu), so that may be the source of the problem.
>>
>> I hope this helps,
>> Paolo
>>
>> On Tue, Dec 1, 2009 at 1:55 PM, Tapas Mishra <tapas@xxxxxxxxxxxx> wrote:
>>>
>>> I am now back to the original problem where the Xen machine is able to
>>> ping other machines on network
>>> here is the output from of the Xen machine the issue started with ssh
>>> [root@localhost ~]# netstat -tualp | grep 22
>>> tcp 0 0 localhost.localdomain:2208 *:*
>>> LISTEN 2594/hpiod
>>> tcp 0 0 192.168.122.1:domain *:*
>>> LISTEN 2829/dnsmasq
>>> tcp 0 0 localhost.localdomain:2207 *:*
>>> LISTEN 2599/python
>>> tcp 0 0 192.168.1.84:58022
>>> qw-in-f83.1e100.net:http ESTABLISHED 4056/firefox
>>> udp 0 0 192.168.122.1:domain *:*
>>> 2829/dnsmasq
>>>
>>>
>>> So it is clear that port 22 is not open here but I have not enabled
>>> firewall and not disabled ICMP echo still it is not able reply back I
>>> am able to have outgoing ssh/ping from Xen machine but any incoming
>>> ssh/ping is notworking while if you read above replies in the thread I
>>> was able to this Xen machine from my LAN but then it was not able to
>>> access internet
>>> Once again I am doing it from start here is what iptables on this machine
>>> say
>>>
>>> [root@localhost ~]# iptables -L
>>> Chain INPUT (policy ACCEPT)
>>> target prot opt source destination
>>> ACCEPT udp -- anywhere anywhere udp dpt:domain
>>> ACCEPT tcp -- anywhere anywhere tcp dpt:domain
>>> ACCEPT udp -- anywhere anywhere udp dpt:bootps
>>> ACCEPT tcp -- anywhere anywhere tcp dpt:bootps
>>>
>>> Chain FORWARD (policy ACCEPT)
>>> target prot opt source destination
>>> ACCEPT all -- anywhere 192.168.122.0/24 state
>>> RELATED,ESTABLISHED
>>> ACCEPT all -- 192.168.122.0/24 anywhere
>>> ACCEPT all -- anywhere anywhere
>>> REJECT all -- anywhere anywhere
>>> reject-with icmp-port-unreachable
>>> REJECT all -- anywhere anywhere
>>> reject-with icmp-port-unreachable
>>>
>>> Chain OUTPUT (policy ACCEPT)
>>> target prot opt source destination
>>> [root@localhost ~]#
>>>
>>> Now what ?
>>> On Tue, Dec 1, 2009 at 7:40 AM, Tapas Mishra <tapas@xxxxxxxxxxxx> wrote:
>>> > I have resolved this probblem here is what I did
>>> > I added to /etc/sysconfig/network-scripts/ifcfg-eth0
>>> > PEERDNS=no
>>> > DNS1=XXX.XXX.XXX.XXX (that is my gateway)
>>> >
>>> > But still I am wondering why did it happned
>>> > ssh and everything else including internet is working fine on the Xen
>>> > machine
>>> > On Tue, Dec 1, 2009 at 7:00 AM, Tait Clarridge <tait@xxxxxxxxxxxx> wrote:
>>> >>
>>> >>> Yes the problem is happening when using the normal kernel also
>>> >>> I checked /etc/resolv.conf
>>> >>> and the nameserver entry there is wrong it should be 4.2.2.6 but each
>>> >>> time I manually edit it is still taking it from ADSL router.
>>> >>
>>> >> Do you have NetworkManager running? If so, stop it and disable it:
>>> >>
>>> >> If you are running CentOS you should be able to change the ifcfg-eth*
>>> >> scripts in /etc/sysconfig/network-scripts to not automatically set DNS
>>> >> according to the gateway.
>>> >>
>>> >> In the ifcfg-ethX (where X is the interface number that your server is
>>> >> connected to the network, eg eth0) file you can add PEERDNS=no to stop
>>> >> it from overwriting the DNS entries.
>>> >>
>>> >
>>> >
>>> >
>>> > --
>>> >
>>> > http://www.abhitech.com
>>> >
>>>
>>>
>>>
>>> --
>>>
>>> http://www.abhitech.com
>>>
>>> _______________________________________________
>>> Xen-users mailing list
>>> Xen-users@xxxxxxxxxxxxxxxxxxx
>>> http://lists.xensource.com/xen-users
>>
>
>
>
> --
>
> http://www.abhitech.com
>
--
http://www.abhitech.com
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
Home