Re: [Xen-users] xen 3.4.1 bonding mode 0

[Brian Krusic <brian@xxxxxxxxxx>]

Hi Thomas,

I'm pretty confused as to what I need to do.
In /etc/sysctl.conf, I set a few values, being either 0,1 or 2 on  
pbond0 as well as bond0 but to no avail for both arp_announce and  
arp_ignore.
I also do;

ip link set pbond0 down
ip link set pbond0 arp off
ip link set pbond0 up

But still get many lines of;

pbond0: received packet with own address as source address


- Brian

On Oct 6, 2009, at 2:40 PM, Thomas Halinka wrote:

> Hi Brian
>
> Am Dienstag, den 06.10.2009, 13:41 -0700 schrieb Brian Krusic:
> > Hi all,
> >
> > I've a feeling this has been covered many times but my research  
> > hasn't
> > showed anything applicable to me.
> >
> > /var/log/messages;
> >
> > pbond0: received packet with  own address as source address
> >
> > Repeats many many times;
> ....
>
> This is an arp-problem. There is an option ARP_ANNOUNCE in /proc-FS or
> sysctl that allows you to control which source address is put in to  
> ARP
> headers
>
> /proc/sys/net/ipv4/conf/$INTERACE/arp_announce
>
> is the place your searching for...
>
> hth,
>
> thomas
>
> > _______________________________________________
> > Xen-users mailing list
> > Xen-users@xxxxxxxxxxxxxxxxxxx
> > http://lists.xensource.com/xen-users
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users