RE: [Xen-users] Manually create Fedora domU on CentOS 5.3 dom0

[Matthias Reif <mattreif@xxxxxxxxxxxxx>]

-----Original Message-----
From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx 
<xen-users-bounces@xxxxxxxxxxxxxxxxxxx>
Sent: Thursday, 24 September 2009 3:09 AM
To: xen-users@xxxxxxxxxxxxxxxxxxx <xen-users@xxxxxxxxxxxxxxxxxxx>
Subject: [Xen-users] Manually create Fedora domU on CentOS 5.3 dom0

I am trying to setup a Fedora 11 domU on my CentOS 5.3 dom0 installation.

I want it to use a dom0 LVM partition as its root partition instead of as a
virtual disk. I understand that Fedora's anaconda won't allow me to do this.

I found this thread on xen-users
http://lists.xensource.com/archives/html/xen-users/2009-06/msg00650.html
Which refers to an Amazon EC2 tech doc, explaining how to install Fedora on a
single root filesystem.

Following these instructions, I managed to install fedora 11 on an LVM
partition. However, when attempting to start this setup as a Xen PV, I get
this error right after pygrub finishes:
Error: (2, 'Invalid kernel', 'elf_xen_note_check: ERROR: Will only load images
built for the generic loader or Linux images')

I'm not sure how to proceed here. Is a special initrd required in a PV
environment ?

More details:
My environment is all 32 bit (xen, dom0, domU)
dom0 kernel is 2.6.18-128.1.10.el5.centos.plusxen
xen is gitco xen 3.3.1
domU kernel is 2.6.30.5-43.fc11.i586

Geert

--
Kobalt W.I.T.
Web & Information Technology
Brusselsesteenweg 152
1850 Grimbergen

Tel  : +32 479 339 655
Email: info@xxxxxxxxxxxx


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users