[Xen-users] bonding with xen 3.3.1

[Alberto Asuero Arroyo <albertoasuero@xxxxxxxxx>]

Hi !!

I'm trying to use my bonding in my xen. I 've a debian 40r6 etch. The bounding works perfectly without xen.

In /etc/modules

bonding miimon=100 mode=balance-alb

when I run xend:

bonding: bond0: first active interface up!
bonding :bond0 link status definitely up for interface eth1
bonding: bond0 release slaves
ADDRCONF(NETDEV_UP): pbond0: link is not ready
bond0: port1(vif1.0) entering disabled state

My /etc/network/interfaces

auto  bond0
iface bond0 inet static
address 10.30.102.254
gateway 10.30.102.5
netmask 255.255.255.0
up /sbin/ifenslave bond0 eth0
up /sbin/ifenslave bond0 eth1

My /etc/xen/xend-config.sxp

                (network-script network-bridge)
                (vif-script vif-bridge)
                (dom0-min-mem 2024)
                (dom0-cpus 0)
                (vnc-listen '0.0.0.0')
                (vncpasswd '')

According to http://wiki.xensource.com/xenwiki/XenNetworking.  "the bridge (xenbr0), peth0, eth0 and vif0.0 are brought up".

For me when I don't use the bonding (using eth0)and started xen peth0 and eth0 are bring up but vif0.0 and the xenbr0 are not bring up. After I do "brctl show" and the bridge name is eth0, is correct?? I don't know if it's correct but its works!!I can do ping, ssh, connect to vnc of domains...

When I start with the bonding (using bond0)  only peth0 and pbond0 are bring up. And "brctrl show" put  two bridges bond0 and eth0. And  the network doesn't work .

any ideas??Are there a tutorial of this or doc?

thanks,

Alberto






 
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users