RE: [Xen-users] Virtual Inteface Assigment

["Ronnie Tartar" <rtartar@xxxxxxxxxxxx>]

I was able to set the xenstore value for vifname in the database using the
following command:

xenstore-write /vm/1463e93a-4c30-9cea-94ea-8fde0ead2ef7/device/vif/0/vifname
purple

But when I get my vif, it still goes to 
vif33.0   Link encap:Ethernet  HWaddr FE:FF:FF:FF:FF:FF  
          inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:115 errors:0 dropped:0 overruns:0 frame:0
          TX packets:97 errors:0 dropped:129 overruns:0 carrier:0
          collisions:0 txqueuelen:32 
          RX bytes:9124 (8.9 KiB)  TX bytes:8839 (8.6 KiB)

I'm not sure 

-----Original Message-----
From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx
[mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Tim Post
Sent: Sunday, June 01, 2008 1:22 PM
To: Ronnie Tartar
Cc: xen-users@xxxxxxxxxxxxxxxxxxx
Subject: Re: [Xen-users] Virtual Inteface Assigment

On Sun, 2008-06-01 at 12:59 -0400, Ronnie Tartar wrote:
> I am looking to use mrtg to map bandwidth usage on my DomU's.
> 
> But by default the vif26.0, vif28.0 is created, can I assign the same vif
> everytime a domu is started?

I use cacti for this but its pretty much the same. In your config (vif=)
just add vifname=blah

>From a live config file:

vif = ['bridge=br0, mac=00:00:6d:8c:2b:41, vifname=6-a-1.0']

The domname is 6-a-1, so I know easily (in cacti) that 6-a-1.0 is eth0
in guest 6-a-1.

HTH

Cheers,
--Tim

-- 
Monkey + Typewriter = Echoreply ( http://echoreply.us )


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users