[Xen-users] DomU does not boot:

[Asim <linkasim@xxxxxxxxx>]

Hi,

I have been stuck at this point for 2 weeks. My domU does not boot. It
just shows this screen and stops:

Xen virtual console successfully installed as xvc0
Event-channel device installed.
netfront: Initialising virtual ethernet driver.
xen-vbd: registered block device major 8
blkfront: sda1: barriers enabled
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
PNP: No PS/2 controller found. Probing ports directly.
i8042.c: No controller found.
mice: PS/2 mouse device common for all mice
md: md driver 0.90.3 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: bitmap version 4.39
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI No-Shortcut mode
vif vif-0: 2 parsing device/vif/0/mac
blkfront: sda2: barriers enabled
XENBUS: Device with no driver: device/console/0
BIOS EDD facility v0.16 2004-Jun-25, 0 devices found
EDD information not available.
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
EXT2-fs warning (device sda1): ext2_fill_super: mounting ext3 filesystem as ext2
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 196k freed


Mine is a xen 3.2.0 32 bit installation on FC8 again 32 bit.

-Asim

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users