| |
|
 |
|
 |
|
|
|
| |
|
|
xen-users
Re: [Xen-users] installing xen domU. plz help
shashank rachamalla wrote:
i recently installed fedora core 6 and even the xen kernel which
shipped with it. i could successfully start xen dom0 but i have
problems installing domUs.
First of all, why on earth would you want to use FC6? FC8 is available.
I prefer RHEL/CentOS 5.1 though. Other than its long lifetime, RHEL 5's
virt-manager creates domU config as a file on /etc/xen, so (for me) it's
easier to manage
1) I downloaded fedora.fc6.20070313.img.tar.bz2_FILES.gz from
jailtime.org <http://jailtime.org>
In that case contact jailtime.org people.
kernel = "/boot/vmlinuz-2.6.18-1.2798.fc6xen"
I would prefer to use pygrub and have domU kernel located on domU, which
is what you get by default if you use virt-manager.
Starting sshd: [ OK ]
*
the boot hangs here. tried a lot to figure this out but nothing works.
*
You probably need to edit /etc/inittab and get mingetty to start on xvc0
or ttyS0. This is a somewhat advanced configuration, so (given your
questions) I would recommend that you start with Centos 5.1 and
virt-manager.
2) I tried to install fc6 domU using virtual manger.
i created a disk image of size 3GB.
used apache to mount my dvd to /var/www/html/fc6
*and started virtual manager. everything went fine and the GUI console
started the fc6 installation from dvd. After some time i get the error
cannot find the file
/images/minstg2.img
*
I am using an adsl modem for connecting to internet and so i access
net through the interface ppp0. the following is my ifconfig
eth0 Link encap:Ethernet HWaddr 00:11:09:15:EF:20
inet addr:192.168.1.2 <http://192.168.1.2>
Bcast:192.168.1.255 <http://192.168.1.255> Mask:255.255.255.0
<http://255.255.255.0>
virbr0 Link encap:Ethernet HWaddr 00:00:00:00:00:00
inet addr: 192.168.122.1 <http://192.168.122.1>
Bcast:192.168.122.255 <http://192.168.122.255> Mask:255.255.255.0
<http://255.255.255.0>
the following is the output of *brctl show
bridge name bridge id STP enabled interfaces
virbr0 8000.000000000000 no
xenbr0 8000.feffffffffff no peth0
vif0.0
*
This shows that your domU is bridged to eth0. It MIGHT work, if you have
DHCP on eth0's network or you configure domU's ip address correctly. I
recommend you choose "Virtual Network" instead of "Shared physical
devices" when creating domU through virt-manager, which would bridge
domU's interface to virbr0 and NAT-ed to outside world.
is the problem because of having a ppp connection or something else.
plz help.
No, it shouldn't matter in this case.
Regards,
Fajar
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
|
|
| |
|
Home