| |
|
 |
|
 |
|
|
|
| |
|
|
xen-users
RE: [Xen-users] Windows 2003, scsi to ide
Hello,
I think the problem could be in the fact, vmware reported to the
W2k3 other devices, like reports xen - so in this case I would expect the
w2k3 system will not run - like if You change the motherboard on the windows
box, You have also heavy problems to boot the system again.
I would propose to test following procedure:
- in device manager of Windows runing under vmware remove the affected
devices and drivers which could make problems, do not recogize new one and
shut down the vmware domain
- migrate it to xen and start there the domain in the emergency mode (press
F8 before start, etc.)
- if it boots, then You have won :-) - and then You just have to go into the
device manager and scan the HW changes and install the new drivers for the
devices reported to windows by xen
With best regards
Artur Linhart
-----Original Message-----
From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx
[mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Petersson, Mats
Sent: Thursday, June 21, 2007 11:14 AM
To: Jeff Williams; xen-users@xxxxxxxxxxxxxxxxxxx
Subject: RE: [Xen-users] Windows 2003, scsi to ide
> -----Original Message-----
> From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx
> [mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of
> Jeff Williams
> Sent: 21 June 2007 09:47
> To: xen-users@xxxxxxxxxxxxxxxxxxx
> Subject: [Xen-users] Windows 2003, scsi to ide
>
> I have a Windows Server 2003 vmware image which I have
> converted across
> to a xen image. However, the vmware image was installed on a SCSI
> virtual disk and booting it under HVM (which uses IDE disks
> only) gives
> me a "Stop 0x0000007B error" as discussed at
> http://support.microsoft.com/kb/314082/. My problem being that the KB
> article covers Windows XP and not Server 2003 and the
> instructions don't
> seem to apply to Server 2003.
It may not be described as working for Win2K3, but I would have thought
that it should work fine. The method of recognizing devices and loading
the corresponding drivers is identical between XP and 2K3 [the actual
kernel in both is identical modulo some minor bugfixes and updates that
are out of sync].
>
> So, has anyone successfully added IDE drivers to a Windows Server 2003
> image? I still have the server running under vmware if
> anything needs to
> be done on the running system, but I would like to migrate it.
I haven't actually done it, but I expect it to work.
--
Mats
>
> Regards,
> Jeff
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
>
>
>
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
__________ Informace od NOD32 2342 (20070621) __________
Tato zprava byla proverena antivirovym systemem NOD32.
http://www.nod32.cz
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
|
|
| |
|
Home