I resolved it. I found a doc on the net somewhere. It was reading a copy
of the Domain0 fstab.
Is there a xensource document that outlines disabling/setting fstab,
ifcfg-eth0, etc.? For some reason I didn't catch that anywhere and had to
rely on an untrusted source.
Thanks for your input.
Matt.
Matthew Dougherty
mdougher@xxxxxxxx
973-325-8556
AIM: mattsei
SKYPE: MatthewDougherty_NJ
-----Original message-----
From: henning.sprang@xxxxxxxxx on behalf of Henning Sprang
[henning_sprang@xxxxxx]
Sent: Wednesday, February 14, 2007 5:53 AM
To: Matthew Dougherty [mdougher@xxxxxxxx]
Cc: xen-users@xxxxxxxxxxxxxxxxxxx
Subject: Re: [Xen-users] New to ZEN: Wrong Logical Volume mounted to "/"
On 2/11/07, Matthew Dougherty <mdougher@xxxxxxxx> wrote:
>
>
>
>
> I setup various logical volumes for different domains. When I start a
> domain, it sets up the root file system and swap correctly but the actual
> "/" is the existing logical volume from domain 0. I'm sure it's something
> simple that I have wrong.
Sorry to say so, but you probbably get no reply on this because it's
hard to understand what's your problem.
You really mean, INSIDE your VM, the / filesystem has THE SAME
contents than the / filesystem of your Domain 0? Are you sure - how
did you check that?
I don't see how this can happen with such a config as you send it.
(apart from, your dom0 root file system is /dev/VirtualVolume/vir%d
...
As you disabling fstab in a guest: that's wrong, either your reading
the wrong howto, or misread it.
You have to disable som, but not all lines in inittab, for some guest
distributions.
Henning
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
Home