|
|
|
|
|
|
|
|
|
|
xen-users
Re: [Xen-users] Problems with xen/kernel / autoloading
On 31 Jan 2007 at 21:51, Per Olav wrote:
> Hi, I'm new to Xen, and have gotten my system up and running, but there
> are some problems.
>
> When I boot the system cold, the xen-kernel locks up with an error like
> this:
>
> ACPI: PCI Interrupt 0000:03:0a.0[A] -> GSI 22 (level, low) -> IRQ 18
>
> The PCI address of the device is not the same each time.
Could it be that the PCI address is always the same, but the interrupt differs?
;-)
I never cared which slot uses which IRQ.
>
> If I boot my system with the standard Etch kernel (2.6.17-2-686), it
> boots fine, and when I do a reboot from this kernel into the xen kernel
> it looks, and boots fine. I've never seen an error like this. What could
> the problem be?
The above is not an error. AFAIK.
Ulrich
>
> I'm using the Xen kernel provided in Debian Etch, 2.6.18-3-xen-686
>
> Cheers
> Per Olav
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- Re: [Xen-users] Problems with xen/kernel / autoloading,
Ulrich Windl <=
|
|
|
|
|