|
|
|
|
|
|
|
|
|
|
xen-users
Dear All,
I have installed xen 3.0 on debian sarge, dom0 is sarge, domu (vm01) is
sarge as well. Since I only have one ip address, so I set up the system
using network bridge and routing.
I have the xend and xendomains started automatically at the boot time, at
this point, I can ssh to dom0 from a remote client,
then I used the /etc/xen/scripts/network-bridge and
/etc/xen/scripts/network-nat scripts to start the netwrok, running the
following scripts which I found on your mailing list:
ifconfig xenbr0 192.168.3.1 netmask 255.255.255.0 up
iptables --flush
iptables --delete-chain
iptables --table nat --delete-chain
iptables --table nat --append POSTROUTING --out-interface xenbr0 -j
MASQUERADE
iptables --append FORWARD --in-interface xenbr0 -j ACCEPT
echo 1 > /proc/sys/net/ipv4/ip_forward
route add -net 192.168.3.0 netmask 255.255.255.0 dev xenbr0
Then I have domu and dom0 running, however I can have ssh connection to my
remote client from both dom0 and domu, but I couldn't have ssh access to
dom0 and domu from the remote client.
What could be the problem?
Thanks
Bin
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Xen-users] no ssh login,
B. Liu <=
|
|
|
|
|