[Xen-users] Network configuration for domU/installing modules for domU

[Amitayu Das <amitayudas@xxxxxxxxx>]

Hi,

I'm having problem in starting few services in DomU after compiling the
xen-unstable source code on FC4. The domain0 starts fine and the
network seems to be setup properly (at least I can do ping/ssh-ing to
and from the machine). Domain 0 also have all the necessary
bridge-setup in place (following execution of the scripts
network-bridge and vif-bridge). 

Now about one of the problems I'm facing. When DomU boots up, messsages say,
"Networking not configured - exiting"

ifconfig -a shows existence of both "eth0" and "lo". Restarting network
brings "lo" up, but no "eth0". If I try to do "ifup eth0", then it says,

/sbin/ifup: configuration for eth0 not found.
Usage: ifup <device name>

I checked with "lsmod" command and no modules were listed. I checked
from the fedora+xen quickstart page
(http://www.fedoraproject.org/wiki/FedoraXenQuickstart), which said
that I needed to install the modules in the guest domain. Since, I'm
not using any rpm to install (which that page suggests), how these
modules can be intalled on guest domain? May that solve my problem eth0
problem, too? 

Any idea/suggestions?

Thanks,
Amitayu

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users