RE: [Xen-users] xen 3.0 boot problem

["Ian Pratt" <m+Ian.Pratt@xxxxxxxxxxxx>]

Has anyone used xen succefully with a qla2300?

What machines have this card?

Ian

> I've installed Xen 3.0-devel on SUSE Linux without any problems.
> But when i tryed to boot the system, i've got a funny problem:
> 
> qla2300 0000:05:01.0: Found an ISP2312, irq 185, iobase 
> 0xf8812000 qla2300 0000:05:01.0: Configuring PCI space...
> qla2300 0000:05:01.0: Configure NVRAM parameters...
> qla2300 0000:05:01.0: Verifying loaded RISC code...
> qla2300 0000:05:01.0: Waiting for LIP to complete...
> 
> until here all works fine, but then:
> 
> input: PS/2 Generic Mouse on synaptcs-pt/serio0 qla2300 
> 0000:05:01.0: LIP reset occured (f7f7).
> qla2300 0000:05:01.0: LOOP UP detected (2 Gbps).
> qla2300 0000:05:01.0: Topology - (F_Port), Host Loop address 0xffff
> scsi3 : qla2xxx
> qla2300 0000:04:02.0:
>   QLogic Fibre Channel HBA Driver: 8.01.00b5-k
>   QLogic QLA2340 - 133MHz PCI-X to 2Gb FC, Single Channel
>   ISP2312: PCI-X (100 MHz) @ 0000:05:01.0 hdma+, host#=3,
> fw=3.03.15 IPX
> Loading kernel/fs/reiserfs/reiserfs.ko
> Waiting for device /dev/sda4 to appear: .....not found --- 
> exiting to /bin/sh $
> 
> if i use the standard (bigsmp) kernel the normal massages are:
> 
> SCSI device sda: 41943040 512-byte hdwr sectors (21475 MB) 
> SCSI device sda: drive cache: write back SCSI device sda: 
> 41943040 512-byte hdwr sectors (21475 MB) SCSI device sda: 
> drive cache: write back
>  sda: sda1 sda2 sda3 sda4
> ....usw.
> 
> Well, my qla2300 has the storage attached not a generic mouse.
> Of course it isn't possible to boot from this mouse. :-(



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users