Re: [Xen-users] Basic Question

[Shahzad Chohan <shahzad.chohan@xxxxxxxxx>]

Hi

Thanks for the reply it was really informative.

If I use the create a config in /etc/xen and refer to say kernel
="/boot/vmlinuz-2.6.11-1.1369_FC4xenU" where do I add extra flags
during bootup, i.e selinux=0. Do I add it to the end of this line
like:

kernel ="/boot/vmlinuz-2.6.11-1.1369_FC4xenU selinux=0" or do I need
to add to a grub.conf file in the domU?

Thanks
Shaz

On 6/15/05, Mark Williamson <mark.williamson@xxxxxxxxxxxx> wrote:
> > Whats the difference between the xenU and xen0 kernel. Is there a
> > technical difference, does this relate to how xen works? Can some one
> > please give me a little summary of how it works.
> 
> The xen0 kernel contains all the drivers required to run in a domU
> (unprivileged guest) *and* all the drivers required to run in dom0 (i.e.
> privileged command interface, device drivers for the real hardware, etc.).
> This'll run in *any* domain.
> 
> The xenU kernel contains only the drivers required to run in a domU - no
> privileged command interface, no drivers for real hardware.  The only
> practical difference is that this kernel is a few hundred kilobytes smaller
> but can only run in domUs.
> 
> HTH,
> Mark
>

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users