>On Fri, 2006-08-04 at 13:36 +0900, Akio Takebe wrote:
>> Hi, Juan
>>
>> Thank you for your comments.
>> I can boot domU with the following modprobe.conf.
>> > alias scsi_hostadapter xenblk
>>
>> But I have some ide errors.
>> After I add extra = 'ide0=noprobe ide1=noprobe ide2=noprobe ide3=noprobe
>> ide4=noprobe' into domU's config, ide errors are not occurred.
>
>I don't get them. Could you post a log, and I will add that ide line to
>the kernel rpm :p
>
>Later, Juan.
Hi, Juan
The below is the boot log w/o ideX=noprobe.
[root@tiger111 linux-2.6-xen-fedora.0802]# xm create /xen/conf/domU.conf -c
Using config file "/xen/conf/domU.conf".
Started domain paravm1
Dentry cache hash table entries: 65536 (order: 5, 524288 bytes)
Inode-cache hash table entries: 32768 (order: 4, 262144 bytes)
Software IO TLB disabled
Memory: 240640k/393216k available (5832k code, 152368k reserved, 4032k data,
272k init)
McKinley Errata 9 workaround not needed; disabling it
register RESCHEDULE_VECTOR (RESCHED0) to xen irq (256)
register IPI_VECTOR (IPI0) to xen irq (257)
Percpu irq 238 is unsupported by xen!
register VIRQ_ITC (timer0) to xen irq (258)
Security Framework v1.0.0 initialized
SELinux: Initializing.
SELinux: Starting in permissive mode
selinux_register_security: Registering secondary module capability
Capability LSM initialized as secondary
Mount-cache hash table entries: 1024
ACPI: Core revision 20060707
Boot processor id 0x0/0x0
SMP mode deactivated.
Brought up 1 CPUs
Total of 1 processors activated (2236.41 BogoMIPS).
migration_cost=0
checking if image is initramfs... it is
Freeing initrd memory: 6416kB freed
DMI not present or invalid.
grant table at e000010000000000
Grant table initialized
NET: Registered protocol family 16
ACPI: bus type pci registered
Brought up 1 CPUs
ACPI: SCI (ACPI GSI 0) not registered
ACPI: Interpreter enabled
ACPI: Using IOSAPIC for interrupt routing
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI init
pnp: PnP ACPI: found 0 devices
xen_mem: Initialising balloon driver.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
NET: Registered protocol family 2
IP route cache hash table entries: 4096 (order: 1, 32768 bytes)
TCP established hash table entries: 16384 (order: 5, 524288 bytes)
TCP bind hash table entries: 8192 (order: 4, 262144 bytes)
TCP: Hash tables configured (established 16384 bind 8192)
TCP reno registered
perfmon: version 2.0 IRQ 238
perfmon: Itanium 2 PMU detected, 16 PMCs, 18 PMDs, 4 counters (47 bits)
PAL Information Facility v0.5
perfmon: added sampling format default_format
perfmon_default_smpl: default_format v2.0 registered
audit: initializing netlink socket (disabled)
audit(1154659468.196:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 2048 (order 0, 16384 bytes)
SELinux: Registering netfilter hooks
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
ACPI Exception (acpi_processor-0681): AE_NOT_FOUND, Processor Device is not
present [20060707]
ACPI: Getting cpuindex for acpiid 0x1
ACPI Exception (acpi_processor-0681): AE_NOT_FOUND, Processor Device is not
present [20060707]
ACPI: Getting cpuindex for acpiid 0x2
EFI Time Services Driver v0.4
Linux agpgart interface v0.101 (c) Dave Jones
RAMDISK driver initialized: 16 RAM disks of 16384K size 4096 blocksize
Xen virtual console successfully installed as tty1
Event-channel device installed.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
hda: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hda: IRQ probe failed (0xfffffffffffffffe)
hda: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hda: IRQ probe failed (0xfffffffffffffffe)
hda: no response (status = 0xa1), resetting drive
hda: IRQ probe failed (0xfffffffffffffffe)
hdb: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdb: IRQ probe failed (0xfffffffffffffffe)
hdb: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdb: IRQ probe failed (0xfffffffffffffffe)
hdb: no response (status = 0xa1), resetting drive
hdb: IRQ probe failed (0xfffffffffffffffe)
hdc: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdc: IRQ probe failed (0xfffffffffffffffe)
hdc: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdc: IRQ probe failed (0xfffffffffffffffe)
hdc: no response (status = 0xa1), resetting drive
hdc: IRQ probe failed (0xfffffffffffffffe)
hdd: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdd: IRQ probe failed (0xfffffffffffffffe)
hdd: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdd: IRQ probe failed (0xfffffffffffffffe)
hdd: no response (status = 0xa1), resetting drive
hdd: IRQ probe failed (0xfffffffffffffffe)
hde: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hde: IRQ probe failed (0xfffffffffffffffe)
hde: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hde: IRQ probe failed (0xfffffffffffffffe)
hde: no response (status = 0xa1), resetting drive
hde: IRQ probe failed (0xfffffffffffffffe)
hdf: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdf: IRQ probe failed (0xfffffffffffffffe)
hdf: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdf: IRQ probe failed (0xfffffffffffffffe)
hdf: no response (status = 0xa1), resetting drive
hdf: IRQ probe failed (0xfffffffffffffffe)
hdg: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdg: IRQ probe failed (0xfffffffffffffffe)
hdg: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdg: IRQ probe failed (0xfffffffffffffffe)
hdg: no response (status = 0xa1), resetting drive
hdg: IRQ probe failed (0xfffffffffffffffe)
hdh: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdh: IRQ probe failed (0xfffffffffffffffe)
hdh: probing with STATUS(0xa1) instead of ALTSTATUS(0x08)
hdh: IRQ probe failed (0xfffffffffffffffe)
hdh: no response (status = 0xa1), resetting drive
hdh: IRQ probe failed (0xfffffffffffffffe)
ide-floppy driver 0.99.newide
usbcore: registered new driver libusual
usbcore: registered new driver hiddev
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
mice: PS/2 mouse device common for all mice
md: md driver 0.90.3 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: bitmap version 4.39
EFI Variables Facility v0.08 2004-May-17
efivars: get_next_variable: status=8000000000000003
TCP bic registered
Initializing IPsec netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
xen privcmd uses pseudo physical addr range [0x20000000, 0x3fffc000000]
(4193728MB)
XENBUS: Device with no driver: device/vbd/2049
Freeing unused kernel memory: 272kB freed
Red Hat nash version 5.0.46 starting
Mounting proc filesystem
Mounting sysfs filesystem
Creating /dev
Creating initial device nodes
Setting up hotplug.
Creating block device nodes.
Loading xenblk.ko module
Loading jbd.ko module
Registering block device major 8
Loading ext3.ko module
Loading scsi_mod.ko module
SCSI subsystem initialized
Loading sd_mod.ko module
register_blkdev: cannot get major 8 for sd
Loading scsi_transport_spi.ko module
Loading mptbase.ko module
Fusion MPT base driver 3.04.01
Copyright (c) 1999-2005 LSI Logic Corporation
Loading mptscsih.ko module
Loading mptspi.ko module
Fusion MPT SPI Host driver 3.04.01
Creating root device.
Mounting root filesystem.
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Setting up other filesystems.
Setting up new root fs
no fstab.sys, mounting internal defaults
Switching to new root and running init.
unmounting old /dev
unmounting old /proc
unmounting old /proc/bus/usb
ERROR unmounting old /proc/bus/usb: No such file or directory
forcing unmount of /proc/bus/usb
unmounting old /sys
modprobe: FATAL: Could not load /lib/modules/2.6.18-rc3/modules.dep: No such
file or directory
modprobe: FATAL: Could not load /lib/modules/2.6.18-rc3/modules.dep: No such
file or directory
INIT: version 2.86 booting
Welcome to Fedora Core
Press 'I' to enter interactive startup.
Cannot access the Hardware Clock via any known method.
Use the --debug option to see the details of our search for an access method.
Setting clock (localtime): Fri Aug 4 11:48:20 JST 2006 [ OK ]
Starting udev: [ OK ]
Setting hostname tiger156: [ OK ]
Checking filesystems
Checking all file systems.
[/sbin/fsck.ext3 (1) -- /] fsck.ext3 -a /dev/sda1
/dev/sda1: clean, 80372/524288 files, 586652/1048576 blocks
[ OK ]
Remounting root filesystem in read-write mode: [ OK ]
Mounting local filesystems: [ OK ]
Enabling local filesystem quotas: [ OK ]
Enabling /etc/fstab swaps: [ OK ]
INIT: Entering runlevel: 3
Entering non-interactive startup
Starting readahead_early: Starting background readahead: [ OK ]
[ OK ]
Checking for hardware changes [ OK ]
FATAL: Could not load /lib/modules/2.6.18-rc3/modules.dep: No such file or
directory
CRITICAL : [ipv6_test] Kernel is not compiled with IPv6 support
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: Device eth0 does not seem to be present, delaying
initialization.
[FAILED]
FATAL: Could not load /lib/modules/2.6.18-rc3/modules.dep: No such file or
directory
CRITICAL : [ipv6_test] Kernel is not compiled with IPv6 support
Starting restorecond: [ OK ]
Starting system logger: [ OK ]
Starting kernel logger: [ OK ]
Starting irqbalance: [ OK ]
Starting portmap: [ OK ]
Starting RPC idmapd: FATAL: Could not load /lib/modules/2.6.18-rc3/modules.dep:
No such file or directory
Starting system message bus: [ OK ]
Can't open RFCOMM control socket: Address family not supported by protocol
Starting hidd: Can't open HIDP control socket: Address family not supported by
protocol
[FAILED]
Loading autofs4: [FAILED]
Starting smartd: [ OK ]
Starting acpi daemon: [ OK ]
Starting cups: [ OK ]
Starting sshd: [ OK ]
Starting vsftpd for vsftpd: [ OK ]
Starting console mouse services: O0o.oops(): [console.c(83)]: Opening console
failed.
[FAILED]
Starting crond: [ OK ]
Starting xfs: [ OK ]
Starting VNC server: no displays configured [ OK ]
Starting anacron: [ OK ]
Starting atd: [ OK ]
Starting Avahi daemon: [ OK ]
Starting HAL daemon: hald(1060): unaligned access to 0x60000fffff08761c,
ip=0x2000000000506670
hald(1060): unaligned access to 0x60000fffff08761c, ip=0x2000000000506561
[ OK ]
Fedora Core release 5.90 (Test)
Kernel 2.6.18-rc3 on an ia64
tiger156 login:
Best Regards,
Akio Takebe
_______________________________________________
Xen-ia64-devel mailing list
Xen-ia64-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-ia64-devel
|
Home