| |
|
 |
|
 |
|
|
|
| |
|
|
xen-devel
Re: [Xen-devel] PCI Passthrough Problems/Questions
On Mon, 2010-10-25 at 13:40 -0400, Konrad Rzeszutek Wilk wrote:
>
> What do you see on your Xen serial output? I presume you cranked up logging:
> loglevel=all guest_lvl=all iommu=verbose on your Xen command line.
>
> Is there anything that shows up when you get the 'Failed to assign.." ?
>
The only messages I get on the serial console after setting those
parameters on the xen.gz kernel line in grub (and rebooting, of course)
are the following:
(XEN) [VT-D]iommu.c:1496: d0:PCI: unmap bdf = 2:0.0
(XEN) [VT-D]iommu.c:1364: d1:PCI: map bdf = 2:0.0
(XEN) domctl.c:848:d0 XEN_DOMCTL_assign_device: assign device (2:0.0)
failed
(XEN) event_channel.c:192:d0 EVTCHNOP failure: domain 1, error -22
-Nick
--------
This e-mail may contain confidential and privileged material for the sole use
of the intended recipient. If this email is not intended for you, or you are
not responsible for the delivery of this message to the intended recipient,
please note that this message may contain SEAKR Engineering (SEAKR)
Privileged/Proprietary Information. In such a case, you are strictly
prohibited from downloading, photocopying, distributing or otherwise using this
message, its contents or attachments in any way. If you have received this
message in error, please notify us immediately by replying to this e-mail and
delete the message from your mailbox. Information contained in this message
that does not relate to the business of SEAKR is neither endorsed by nor
attributable to SEAKR.
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
|
|
|
| |
|
Home