I added some lines to xend-pci-quirks.sxp in order to make the Intel
Quad NIC 82576 working. The message to check the permissive value in
syslog disappeared and I get cable connect messages inside the DomU, but
unfortunately I can not ping the device in the DomU.
Here the lspci data as requested in xend-pci-quirks.sxp:
(pci_config_space_fields
# Entries are formated as follows:
# <register>:<size>:<mask>
# size is measured in bytes (1,2,4 are valid sizes)
# mask is currently unused; use all zero's
....
'000000a8:2:00000000' # Intel Quad nic... no idea what
....
/etc/xen# lspci -s 10:00.1 -vv
10:00.1 Ethernet controller: Intel Corporation Device 10e8 (rev 01)
Subsystem: Intel Corporation Device a02b
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin B routed to IRQ 17
Region 0: Memory at d9d40000 (32-bit, non-prefetchable) [size=128K]
Region 1: Memory at da400000 (32-bit, non-prefetchable) [size=4M]
Region 2: I/O ports at 6020 [disabled] [size=32]
Region 3: Memory at d9d04000 (32-bit, non-prefetchable) [size=16K]
Capabilities: [40] Power Management version 3
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot
+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [50] Message Signalled Interrupts: Mask+ 64bit+ Queue=0/0
Enable-
Address: 0000000000000000 Data: 0000
Masking: 00000000 Pending: 00000000
Capabilities: [70] MSI-X: Enable- Mask- TabSize=10
Vector table: BAR=3 offset=00000000
PBA: BAR=3 offset=00002000
Capabilities: [a0] Express (v2) Endpoint, MSI 00
DevCap: MaxPayload 512 bytes, PhantFunc 0, Latency L0s <512ns,
L1
<64us
ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset+
DevCtl: Report errors: Correctable+ Non-Fatal+ Fatal+
Unsupported+
RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+ FLReset-
MaxPayload 128 bytes, MaxReadReq 4096 bytes
DevSta: CorrErr+ UncorrErr- FatalErr- UnsuppReq+ AuxPwr-
TransPend-
LnkCap: Port #4, Speed 2.5GT/s, Width x4, ASPM L0s L1, Latency
L0
<4us, L1 <64us
ClockPM- Suprise- LLActRep- BwNot-
LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain- CommClk-
ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s, Width x4, TrErr- Train- SlotClk+
DLActive-
BWMgmt- ABWMgmt-
Capabilities: [100] Advanced Error Reporting <?>
Capabilities: [140] Device Serial Number 04-ad-38-ff-ff-21-1b-00
Capabilities: [150] #0e
Capabilities: [160] #10
Kernel driver in use: pciback
Kernel modules: igb
Regards,
Alexander
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
|
Home